CertifQ

OPTIONS Most variations in a product resulting in defects are due to Special Causes Variability in a process is due to Common and Special Causes In the short term, one should focus on reducing Common Causes Special Causes result in a process to go unstable...

OPTIONS A stable process is controlled An unstable process is not in control A stable process doesn’t have Special Causes of Variation, mostly A stable process is capable ANSWER A stable process is capable EXPLANATION you cannot definitively say that a stable process is capable...

OPTIONS 4 2 2/Square root (33) Cannot determine ANSWER 2/Square root (33) EXPLANATION By applying standard CLT Clauses.

OPTIONS Special Causes are present There is no variation whatsoever Common causes are present Some times, structural variation are present. ANSWER Special Causes are present EXPLANATION Other options are not serious considerations. When a process is not in control, it is because of special causes...

OPTIONS ReliableDurablePredictable outputRepeatable output ANSWER Predictable output EXPLANATION Stability is often referred to as a state when process produces consistent and predictable output, so Predictable output is the correct answer.

OPTIONS Discrimination is not adequate Gage needs replacement Operators need to be trained Discrimination is adequate ANSWER Discrimination is not adequate EXPLANATION NDC < 5 means the measurement system in the gage study is unable to differentiate between different measurements accurately, thus the discrimination is...

OPTIONS Stability Accuracy Discrimination Reliability ANSWER Discrimination EXPLANATION When the talk is on dividing the data in discrete categories, we refer it to as Resolution or Discrimination.

OPTIONS Noise and Reproducibility Repeatability and Signal Noise and Process Variation Gage Variation and process variation ANSWER Gage Variation and process variation

OPTIONS The Measurement system suffers from 2% linearity error The Measurement system suffers from 2% accuracy error The Measurement system suffers from 2% bias error None of the above ANSWER The Measurement system suffers from 2% bias error EXPLANATION Bias percentage refers to Bias error....

OPTIONS StabilityLinearityPrecisionRepeatability ANSWER Stability EXPLANATION Linearity, Precision and Repeatability have their own directions to give in a MSA, while stability often refers to consistency and predictability, so Stability is correct.